Asus eeePC 1005PE LVDS Cable pinout

I'm posting this pinout, because it can't be easily found, and using a multimeter it takes a lot to figure out, like it did for me

MB Connector	Panel back connector	Description
1	2	3.3VDD
2	4	EDID eeprom power ( 3.3V)
3	6	EDID eeprom CLK
4	7	EDID eeprom DATA
5	28	VDD_EN ( Active high, 3.3v)
6	30	VLED_EN (Active high, 3.3v)
7	22	GND
8	8	LVDS Channel 0 -
9	9	LVDS Channel 0 +
10	11	LVDS Channel 1 -
11	12	LVDS Channel 1 +
12	14	LVDS Channel 2 -
13	15	LVDS Channel 2 +
14	22	GND
15	17	LVDS Clock -
16	18	LVDS Clock +
17	1	GND
18	5	Backlight PWM ADJ
19	25	Led VCC ( 5V )
20	24	Led VCC ( 5V )

If you are planning to reuse the panel with an MT6820 board, set the panel voltage to 3.3volts , connect 3.3VDD and VDD_EN together, and connect all the gnd pins to gnd too.
About the backlight, for me it worked leaving VLED_EN open ( unconnected ) and ADJ connected to the BL pin of the mt6820 ( brightness , unless i've swapped for error the pins , does not seem to work )

The whole thing will draw about 1A @ 5V, so if you get an Y cable with a switch ( to prevent the mt6820 from powering on too early ), you can run it from two usb ports

The correct jumper configuration for the board is with only A closed , and all other open